Offering 6,284 videos in 230 categories! ...and 9,756 customer reviews!
Your Account |
Help |
I liked the information provided by the video and am making some of the test/setup items in the video. Hope there are more of the same type.
I enjoyed the video very much. I only wished Rudy had covered internal threading, as he does so very good with his instructions. He keeps moving with his lessons and at no time did I feel he wasted any of my time (viewed it twice with several re-runs to catch everything he was teaching.)
I really liked this video lesson. I had to watch it twice to make sure I didn't miss anything. Paused it several times to make notes, there is a lot of information there. I would heartily recommend it to anyone else who is unsure about cutting their first threads with their lathe.
As with all the videos I have rented, this one also was very useful and presented the information very clearly.
Great video! I was able to disassemble my unit and after cleaning, lubing, and reassembling it, I was able to notice very much improvement in the smoothness of the tables and headstock. It really helped. I bent a 1/4" threaded rod to hold the dial indicator for alignment and it feels a lot better to have the headstock/column so close to perpendicular to the table. And, in the future, should I feel the need to recalibrate the mill,--no problem. Thanks. Gary
This is one very fast moving, information loaded, well done video. I thoroughly enjoyed it! By moving right along, he keeps your attention. I have since ordered his lathe videos and will order more as I can. Gary
Disk number 2 repeated a lot of stuff seen in disk number 1. Replacement of the brake hose, clutch cable, throttle and idle-off cable. It did, however, show clutch adjustment very well; and I liked the stress put on protecting the painted areas when wrenching near any of them. I suspect that the number 3 disk will also review the same replacements and add something new at the end, so, I will not be ordering disk 3 unless I am told differently (that it shows all new stuff). I did like the first program a lot and the second program less owing to the time wasted replaying the replacements.
It was a waste of time! Couldn't hear half of what he was saying due to some fool hammering away off-camera. If it was meant to be a cartoon, it failed. If it meant to seriously explain about the paintless dent repair methodology, it failed. By far not up to the standards of the other instructional videos I have viewed and enjoyed.
Very good video, have ordered his other one. Seemed rather long, but, I liked the depth and also his explanation that this wasn't the only way to do something, just that he had worked it out that this was one of the best ways.
Excellent video! I now plan to purchase my own copy from them as we are picking up a 2008 Electa Glide Ultra..
The second video in this 2 video set was information on the older bikes and did not pertain to my new purchase.
The narrator really has a shop knowledge of the mill and is able to get across the ways of using a mill other than the Bridgeport only. Liked the video very much and hope he has others.
I liked the video and thought it was very helpful with the flycutting and dovetailing information.
I liked it. I sharpened my 1/2" drill bit today and using his simple method on the belt sander worked very well. I am happy with just that little tidbit.
The presenter knew his subject and had a nice presentation.
